The Cut & Jet Shuttle is a dual table machine combining a 5 axis mitre saw and 5 axis waterjet cutting machine. The shuttle table rotates automatically to allow loading or unloading of a second slab whilst the other side is in operation.
The Cut & Jet Shuttle's ability to improve efficiencies by loading during cutting provides a significant increase in production capacity and the ability to produce more kitchens per day in less time.
Not after a dual table machine? Check out the single table system, Prussiani's Cut & Jet 5.
With automatic tilting from 0 - 60 degrees, a diamond blade remains the fastest way to perform cuts and mitres in stone. For high production cutting, the Cut & Jet Shuttle saw by Prussiani has an 18HP motor with 425mm blade capacity.
With a 5 axis waterjet cutting head for -5° to 60° tilt, the Cut & Jet Shuttle combines the versatility of waterjet and the speed of a diamond blade into one operation for the fastest production times. Once straight and mitre cuts have been completed the 5 axis waterjet cutting system then cuts all curves, sinks and tap holes.
The numerical control system has been engineered and prepared to operate in automatic mode even without an operator present (e.g. at night or during breaks). Sensors constantly monitor the machine to ensure smooth operation. In case of anomalies such as lack of water, compressed air, lubricating grease, etc. the system will shut down.
The Shuttle's system of motorised rotating tables allows the operator to load and unload slabs whilst the machine is cutting on the other table, thus dramatically reducing downtime. The Cut & Jet Shuttle has overall dimensions of 7.6m (l) x 8.35m (w) x 3m (h).
A high definition video camera continuously frames the working area on a screen above the controller and allows the operator to follow the system's progress through a remote monitor.
For operator safety, the Cut and Jet Shuttle system is surrounded by a safety enclosure and safety light curtain across the loading area.
The Cut & Jet Shuttle with 5 axis mitre saw & waterjet (both capable of up to 60 degree tilt) allows operators to perform curves, straight cuts, mitres and sink and tap holes all in one operation for maximum efficiency and profitability.
Superior engineering of the intensifier allows the Jetline pump to deliver low maintenance costs and quiet operation. With a touch screen controller providing a snapshot of key operating conditions, the Jetline also tracks HP seal life and automatically switches between high pressure waterjet cutting and low pressure piercing depending on the thickness and density of the workpiece.
This Integral Diamond Eductor waterjet cutting head consistently demonstrates superior performance compared to other types of cutting heads, delivering reduced operating costs and a faster cutting speed with less garnet abrasive required per linear metre of cut.
The Abraline V accurately monitors the availability of garnet during the entire waterjet cutting process, ensuring cutting is never interrupted due to garnet refilling.
The manipulator with suction cups gives the operator the ability to rotate workpieces from 0 to 370 degrees. The suction cups lift individual pieces with a maximum weight of 210 kg and minimum width of 120mm.